Huawei H12-323_V2.0 Practice Verified Answers - Pass Your Exams For Sure! [2025]
Valid Way To Pass Huawei-certification's H12-323_V2.0 Exam
NEW QUESTION # 120
In a WLAN outdoor wireless coverage scenario, using external antenna coverage, the throughput of the wireless terminal remains at a low value. Which of the following may be the reasons for this phenomenon? (Multiple choice)
- A. Terminal speed limit is configured
- B. Excessive interference leads to decreased throughput
- C. RSSI is too low, link establishment speed is slow
- D. The test terminal does not support 802.11n/ac/ax
Answer: A,B,D
NEW QUESTION # 121
PMK fast roaming is mainly aimed at scenarios using WPA/WPA2-802.1XWPA3-802.1X security policies. Through the paired master key PMK (Pairwise Master Key) caching technology, the
802.1X authentication process is omitted, and only key negotiation is required, with low latency.
- A. False
- B. True
Answer: B
NEW QUESTION # 122
After the terminal associates with the wireless signal, a roaming test is performed through the CloudCampus APP. The roaming test results are shown in the figure below. Then the signal strength of the terminal associated with the AP after roaming is () dBm.
Answer:
Explanation:
-33
NEW QUESTION # 123
When an engineer was debugging a wireless network at a customer site, the RF tuning function configured on the device did not take effect. The engineer initially suspected that the AP was unable to detect neighbor information.
Which of the following command lines can an engineer enter on the wireless console to view AP neighbor information?
- A. <WAC>display ap neighbor
- B. <WAC>display neighbor all
- C. <WAC>display pim neighbor
- D. <WAC>display ap 11dp neighbor
Answer: B
NEW QUESTION # 124
In the WAC cloud management architecture, Huawei's cloud management platform iMaster NCE- Campus is mainly used to uniformly manage and configure wireless devices. Before 1C is injected into iMaster lCE-Campus, which of the following methods can be used to switch WAC to cloud mode? (Multiple choice)
- A. Registration Center
- B. CicudCampus APP
- C. DHCP method
- D. Command line
Answer: A,C,D
NEW QUESTION # 125
In the network design of WLAN project in warehousing and logistics industry, which of the following descriptions about the channel planning considerations is correct? (Multiple choice)
- A. Scanning terminal rate support
- B. Warehouse vertical three-dimensional channel planning
- C. Warehouse horizontal plane channel planning
- D. Channel support for QR code scanning terminals
Answer: B,C,D
NEW QUESTION # 126
In a certain WLAN network, load balancing, intelligent roaming and spectrum navigation functions are deployed on the radio frequency. The engineer then configures the Mesh service on the radio frequency. This will cause the Mesh service to fail to take effect.
- A. False
- B. True
Answer: B
NEW QUESTION # 127
Drag and Drop Question
Through the radio frequency tuning function, the AP's channel and power can be dynamically adjusted to keep the channels and power of each AP managed by the same WAC relatively balanced, ensuring that the AP works in the best state. Please sort the following radio frequency tuning workflows.
Answer:
Explanation:
NEW QUESTION # 128
When there are many users in the WLAN network, in order to ensure the online experience of online users, the user connection admission control CAC (Call Admission Control) function can be deployed.
- A. False
- B. True
Answer: B
NEW QUESTION # 129
When two APs work on the same channel, there may be interference and delay when sending and receiving data at the same time, which will reduce network performance. Therefore, it is recommended to plan different working channels that do not interfere with each other between APs with overlapping coverage areas.
- A. False
- B. True
Answer: B
NEW QUESTION # 130
In a WLAN network, users can use the Wi-Fi test function in the CloudCampus app to test the wireless network and services.
Among them, Wi-Fi health check can enable Jie to comprehensively detect the Wi-Fi network status from which of the following aspects? (Multiple choice)
- A. Business Experience
- B. Wi-Fi stability
- C. Cybersecurity
- D. Coverage test
Answer: A,B,C,D
NEW QUESTION # 131
A retail store has newly built a WLAN network. For the in-store barcode scanner business, users require multiple barcode scanners to connect to the same SSID, but each barcode scanner needs to be configured with a different key, and there is no need to deploy an authentication server.
Which of the following authentication methods can engineers use to meet the above requirements?
- A. WPA/WPA2-802.1X authentication
- B. WPA/WPA2-PPSK authentication
- C. Static WEP authentication
- D. WPA/WPA2-DPSK authentication
Answer: B
NEW QUESTION # 132
In NaviAC networking, the data forwarding mode in the vapprofile policy must be configured as tunnel forwarding, otherwise NaviAC cannot receive service data
- A. False
- B. True
Answer: B
NEW QUESTION # 133
Wireless network capacity optimization needs to consider the service types and user models of customers in different scenarios, and provide customers with capacity optimization suggestions based on network construction standards. When a customer has 300 users accessing the existing network, the concurrency rate is 40%, the average bandwidth of a single user is 16Mbps, and the terminal bandwidth of the currently selected AP is 16 Tlbpsi, the number of concurrent terminals is 15, then in order to meet the capacity requirements, () APs need to be deployed in the area.
Answer:
Explanation:
8
NEW QUESTION # 134
When an engineer was optimizing a wireless network, he used CloudCampus to understand the surrounding wireless signal interference. The APP is tested and the test results are shown in the figure below.
Which of the following options are correct for describing the wireless signal interference in the current environment? (Multiple choice)
- A. The current wireless signal operating bandwidth is 20Mhz
- B. It is recommended that engineers set the AP's working channel to 44
- C. The wireless signal strength on channel 36 is high, so it is recommended to avoid using channel
36. - D. Wireless signals are mainly distributed on channels 36, 52, and 60
Answer: B,C,D
NEW QUESTION # 135
A customer's existing network has a blind spot in wireless signal coverage, resulting in some wired terminals being unable to access the network.
Engineers adjust the transmit power of the surrounding AF to expand the coverage and fill in the blind spots. Which of the following configuration commands for manually adjusting the AR transmit power is correct?
- A. [WAC-wlan] ap-id1
[WAC-wlan-ap-1] radio
[WACwlan-radio-1/0] calibrate auto-txpower-select enable
[WAC-wlan-radio-1/0] eirp23
[WAC-wlanradio-1/0 ] radio1
[WAC-wlan-radio-1/1 ] calibrate auto-txpower-select enable
[WAC-wlan-radio-1/1] eirp 23 - B. [WAC-wlan-ap-group-ap-group1] radio 0
[WAC-wlan-group-radio-ap-group1/0] calibrate auto txpower-select enable
[WAC-wlan-ap-group-ap-group1] radio
[WAC-wlan-group-radio-ap-group1/1] calibrate auto-txpower-select enable
[WAC-wlan-group-radio-ap-group1/1] quit
[WAC-wlan-view] calibrate enable manual
[WAC-wlan-view] calibrate manual startup - C. [WAC-wlan-ap-group-ap-group1] radio
[WACwlan-group-radio-ap-group1/0] calibrate auto-channel-select enable
[WAC-wlan-ap-group-ap-group1] radio1
[WAC-wlan-group-radio-ap-group1/1] calibrate auto-channel-select enable
[WAC-wlan-group-radio-ap-group1/1] quit
[WAC-wlan-view] calibrate enable manua
[WAC-wlan-view] calibrate manual startup - D. [WAC-wlan] ap-id 1
[WAC-wlan-ap-1] radio 0
[WAC-wlan-radio-1/0] calibrate auto-txpower-select disable
[WAC-wlan-radio-1/0] eirp 23
[WAC-wlan-radio-1/0] radio 1
[WAC-wlan-radio-1/1] calibrate auto-txpower-select disable
[WAC-wlan-radio.1/1jeirp 23
Answer: D
NEW QUESTION # 136
In a WLAN network, the working status of the AP will be affected by the surrounding environment.
By dynamically adjusting the AP's channel, power, and frequency band, each AP managed by the same TAC can ensure coverage while avoiding interference as much as possible, ensuring that the AP works in the best state. Which of the following are solutions supported by Huawei's wireless radio frequency automatic tuning? (Multiple choice)
- A. Dynamic Power Scaling
- B. Dynamic frequency band adjustment
- C. Dynamic channel adjustment
- D. Dynamic Bandwidth Selection
Answer: A,B,C,D
NEW QUESTION # 137
In roaming scenarios, some terminals will not roam to an AP with better signal even if the AP forces them to go offline due to individual differences. Instead, they will "stubbornly" associate with the AP they last associated with, or even stop associating. For such terminals, WAC will directly kick them offline.
- A. False
- B. True
Answer: A
NEW QUESTION # 138
In an indoor semi-open scene, there is a "colored thick glass" between the mobile phone and the AP. The parameters for calculating the signal field strength are shown in the figure. Without considering other factors, if the field strength at the location of the mobile phone meets the requirement of 2.4G RF signal field strength of -65dBm, the maximum transmission distance attenuation value is () dB.
Answer:
Explanation:
83
NEW QUESTION # 139
As shown in the figure, there are four users under the same antenna of an AP. They all need to transmit data. It is known that User1 has occupied the channel for 3 times and transmits a round of data for 2 times; User2 has occupied the channel for 4 times and transmits a round of data for
4 times; User3 has occupied the channel for 6 times and transmits a round of data for 6 times; User4 has occupied the channel for 7 times and transmits a round of data for 7 times. After the Airtime scheduling function is enabled, according to the Airtime scheduling mechanism, which of the following users will be prioritized for scheduling ?
- A. User1
- B. User3
- C. User2
- D. User4
Answer: D
NEW QUESTION # 140
When surveying office scenes, you need to pay attention to the impact of load-bearing columns and partitions on coverage. In addition, if the roof is an integral suspended ceiling, the AP should be placed near the maintenance port as much as possible. If it is a metal suspended ceiling, you can choose to place the AP under the ceiling or wall-mount it.
- A. False
- B. True
Answer: B
NEW QUESTION # 141
As shown in the figure, this is the toolbar of WLAN Planner. Users can click these icons to perform quick operations when planning and designing WLAN networks.
Among them, when clicking the "Replace" icon, which of the following devices is not included in the replacement?
- A. Switch
- B. Obstacles
- C. AP
- D. WAC
Answer: D
NEW QUESTION # 142
......
Huawei H12-323_V2.0 exam is a challenging and comprehensive certification that requires candidates to have hands-on experience with wireless network technologies. Candidates must be able to apply their knowledge to real-world scenarios, identify issues, and provide solutions that are both effective and efficient. H12-323_V2.0 exam is intended for professionals who want to demonstrate their expertise in wireless network technologies and advance their careers in this field.
Huawei H12-323_V2.0 (HCIP-WLAN V2.0) Certification Exam covers a wide range of topics related to WLAN technologies, including WLAN planning and optimization, WLAN deployment and management, WLAN troubleshooting, and WLAN security. H12-323_V2.0 exam is designed to test the candidate's ability to design, deploy and manage complex WLAN networks using Huawei technologies, and to troubleshoot and resolve issues that may arise in these networks.
Huawei H12-323_V2.0 Pre-Exam Practice Tests | DumpsTorrent: https://braindumps2go.dumpstorrent.com/H12-323_V2.0-exam-prep.html