100% PASS RATE BICSI Other Certification IN101_V7 Certified Exam DUMP with 115 Questions
Updates For the Latest IN101_V7 Free Exam Study Guide!
NEW QUESTION # 44
Which of the following is a floor serving space that serves as a point of termination for horizontal and backbone cables?
- A. ER
- B. EF
- C. TR
- D. Work area
Answer: C
NEW QUESTION # 45
Which of the Two organizations jointly oversee the worldwide standardization of telecommunications cabling?
- A. National Electrical Contractors Association (NECA) and National Fire Protection Association (NFPA)
- B. Alliance for Telecommunications Industry Solutions (ATIS) and Society for Cable Telecommunications Engineers (SCTE)
- C. International Organization for Standardization (ISO) and International Electrotechnical Commission (IEC)
- D. Comite Europeen de Normalisation Electrotechnique (CENELEC) and Electronic Industries Association (EIA)
Answer: C
NEW QUESTION # 46
What is the maximum number of work areas that a CP should serve?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: D
NEW QUESTION # 47
Which of the following is a property of an electromagnetic field built around a conductor that opposes any changes in current flow in a circuit?
- A. Resistance
- B. Capacitance
- C. Impedance
- D. Inductance
Answer: D
NEW QUESTION # 48
Which of the following terms describes the unwanted signal coupling from a disturbing pair of a 4-pair cable channel to a disturbed pair of another 4-pair channel?
- A. ACRF - attenuation to crosstalk ratio far end
- B. AXT - alien crosstalk
- C. NEXT - Near end crosstalk
Answer: B
NEW QUESTION # 49
If the situation requires, a conduit should be terminated _______ the plywood backboard?
- A. Below
- B. Above
- C. Through
Answer: C
NEW QUESTION # 50
How much sheath of the cable needs to be removed in order to properly terminate an 8P8C?
- A. 25mm (1")
- B. 38 mm (1.5")
- C. 12.7mm (0.5")
- D. 6.3mm (0.25")
Answer: C
NEW QUESTION # 51
What grade of plywood is recommended for use with ICT systems?
- A. A/D
- B. C/D
- C. B/C
- D. A/C
Answer: D
NEW QUESTION # 52
What is the markings for non-conductive optical fiber riser cable?
- A. OFNG
- B. OFNR
- C. OFNP
- D. OFCR
Answer: B
NEW QUESTION # 53
Which of the following describes a nonmechanical firestop system that forms a hard char when exposed to flame?
- A. Intumescent
- B. Ablative
- C. Endothermic
- D. Elastomeric
Answer: B
NEW QUESTION # 54
A third 90-degree bend may be permitted in a conduit run if one of the bends is located within ____ of the cable feed end?
- A. 483mm (19")
- B. 375 mm (15")
- C. 300 mm (12")
- D. 450 mm (18")
Answer: C
NEW QUESTION # 55
Light pulses in optical fiber cables are subjected to a loss in power as the light pulses travel along the optical fiber. Which of the following terms is used to describe this phenomenon?
- A. Attenuation
- B. Grounding
- C. Crosstalk
- D. Frequency
Answer: A
NEW QUESTION # 56
Which type of tester includes a set of modular plugs?
- A. Tone generator
- B. Inductive amplifier
- C. Cable-end locator kit
- D. Multimeter
Answer: C
NEW QUESTION # 57
Which of the following are typically used to support cables between a cable tray and work area outlets?
- A. Pipe hanger
- B. Trapeze
- C. Innerduct
- D. J-Hook
Answer: D
NEW QUESTION # 58
Which of the following types of cable produces very little smoke when burned?
- A. CMUC
- B. LSZH
- C. CM
- D. CMG
Answer: B
NEW QUESTION # 59
During the troubleshooting phase, what is the first step?
- A. Verify
- B. Repair
- C. Isolate
- D. Test
Answer: A
NEW QUESTION # 60
Which of the following tend to cause sheath damage during cable pulling?
- A. FMC/FMT
- B. RMC/IMC
- C. EMT/ENT
Answer: A
NEW QUESTION # 61
Which of the following PPE items MUST be worn at all times when you are working with or handling OF?
- A. Eye Protection
- B. Hearing Protection
- C. Breathing Protection
- D. Fall Protection
Answer: A
NEW QUESTION # 62
What is the primary purpose of an electrical grounding system?
- A. Ensure a minimal level of acceptable performance for a building's telecommunications infrastructure
- B. Protect and provide organization for cables, splices and connectors
- C. Prevent unauthorized access to the buildings electrical protection system
- D. Enhance personnel safety and reduce the likelihood of a fire hazard
Answer: D
NEW QUESTION # 63
......
BICSI IN101_V7 exam is based on the BICSI Installer 1 training course, which covers the basic principles of cabling infrastructure installation. IN101_V7 exam covers a wide range of topics, including the installation of copper and fiber optic cables, the use of tools and equipment, safety procedures, and industry standards and codes.
Best IN101_V7 Exam Preparation Material with New Dumps Questions https://braindumps2go.dumpstorrent.com/IN101_V7-exam-prep.html